We will discuss the design concept of a drive shaft subjected to a fixed load. A drive shaft is supported by bearings at both the ends (and at regular interval in the centre for longer shafts). The belt driven pulleys are usually placed over the shaft in between the bearings.

Aug 3, 2021 · shaft design DESIGN OF SHAFT FOR RIGIDITY: In many cases, the shaft is to be designed from a rigidity point of view. For a shaft subjected twisting moment, the angle of twist is given by, the angle of twist = TL / GJ Where T = Torque applied. L = Length of the shaft

A shaft is normally designed to transfer torque from a driving device to a driven device. If the shaft is rotating, it is generally transferring power and if the shaft is operating without rotary motion it is simply transmitting torque and is probably resisting the transfer of power.

On a power-driven ship, the drive shaft, or propeller shaft, usually connects the propeller outside the vessel to the driving machinery inside, passing through at least one shaft seal or stuffing box where it intersects the hull.

In automobiles drive shaft is connected with two ends by using universal joints to transmit power at angle. These shafts are experienced to twisting movement and dynamic loading due to transport acceleration of vehicle. Simple arrangement of drive shaft is shown in following figure.

In present work an attempt has been made to design a driveshaft for heavy duty truck on the basis of maximum torque transmitting capacity, maximum shear stress produced & critical speed requirement as design criteria followed by virtual simulation which uses Finite Element Analysis Software for evaluating the product performance. 1.

composite drive shaft. The composite drive shaft made up of high modulus material is designed by using CAD software and tested in ANSYS for optimization of design or material check and providing a best material. The replacement of composite materials can results in considerable amount of weight reduction if compared to conventional steel shaft.

When determining the optimum drive line angles for a vehicle, a good rule of thumb to follow is the six to one-and-a-half rule. The drive line working angle should not exceed six degrees, and the adjoining u-joints at either end of a shaft should be different …

Jun 13, 2012 · Automobile propeller shaft design calculation procedure will be discussed in this drive shaft design tutorial through an example cardon shaft design problem.

Design of Shaft and Analysis. CATIA enables the creation of 3D parts, from 3D sketches, sheet metal, composites, and melded, forged or tooling parts up to the definition of mechanical assemblies. The software provides advanced technologies for mechanical surfacing.