1. So I started off with this pretty big block of maple. First I needed to make sure it was square, so using a smoothing plane here to joint the ed...

2. Now let's move on to the lights. So I have this LED strip here, and you can cut them every three lights on the copper section. So for this desig...

3. Now let's get to work on the wood. So I need to cut a dado in the base, so the back can sit inside it at an angle. I also need a dado in the bac...

4. Now, I'm going to run a wire down from the light so drilling a hole here so I can get it to the backside. And testing if that fits and that was...

5. Time to assemble. So making sure I'm getting the wire through, and then gluing the pieces together. And a little gentle tapping to get it in pla...

6. OK, so time to connect the wiring. So I have the wire coming up through the back piece, so I split it off, and I'm soldering the positive to the...

7. So almost done, a little fine sanding, and then I'm putting on a coat of my tung oil wax polish. OK, so to really finish this piece off, I'm cut...

8. For a much better perspective, make sure to watch the video going over each step!