In a direct mount the hydraulic pump is mounted directly to the output flange of the PTO. Direct mounting is the most common type of PTO in the mobile equipment industry. A concern to be wary of when direct mounting a pump is a condition known as shaft fretting. This is rapid spline wear of the PTO and pump shafts.

3. 362-424 DT12 Hydrocar P89 Rear Mounted PTO with Prep for Hydraulic Pump (1:1 PTO Ratio). This option is the same as option #1 (362-2HB), except that the PTO Drive ratio here is 1:1. With Option #3 (362-424): - The PTO drive assembly mounting flange offers SAE-B mounting for 2 or 4 bolt configurations and

Open the PTO carton and find the mounting kit (studs and cap screws) enclosed with your PTO. Visual inspection of the PTO will indicate which . mounting holes in the PTO will not accept cap screws. Install the enclosed . studs in the transmission housing holes that correspond to those PTO . holes which will not accept cap screws.

Locate the PTO mounting kit. Find alignment studs (2 pcs), and install in the correct location (see below). 5. Install supplied gasket over alignment studs. A thin coating of approved transmission fluid on gasket is recommended to help hold gasket to opening. Mount PTO with provided capscrews and washers. Check for proper PTO fit

Sep 20, 2021 · Then, mount the PTO to the adapter with the correct gasket which you set aside. 16. Start the truck engine (with PTO and transmission in neutral) for only a few seconds and listen for any unusual noises. Keep the PTO and transmission running time as short as possible until the transmission is refilled with transmission fluid. 17.

• Both mounting pads have SAE Standard-Duty six-bolt hole patterns. • As shipped from the Allison factory, each PTO mount-ing pad is sealed with a gasket and a cover plate. • If the transmission includes the PTO drive provision, a large PTO drive gear is located under the PTO cover plate. A489A TRANSMISSION VIEWED FROM REAR Figure 1: PTO ...

Drawbar support details: Photo of PTO & hitch area. Measure height of center of PTO shaft down to upper drawbar support. Other measurements may be necessary. · PTO shaft NOTE: Large 1000 (1 ¾-20) is standard. Small 1000 (1 3/8-21) is available for smaller pumps.

(1) - Elastomer controlled squeeze seal required at PTO Transmission mounting surface. SAE 8-bolt PTO opening is standard on all Endurant XD Series transmissions. Note: (2) - DIN 5462 80x80 and 121x111 mounting. 35 tooth external spline. Rear PTO is standard on all Endurant XD Series Transmissions. Note: (3) - PTO HP/TQ rating is 8-bolt only ...

PTO Type / Model. Expand the PTO Type / Model facet. Assembly Arrangement. Expand the Assembly Arrangement facet. Speed Ratio / Gear Ratio. ... Expand the Sensor Mounting Thread Size or Diameter facet. Terminal Quantity. Expand the Terminal Quantity facet. Availability. View results (40,772) Sort by: Sort by. 40,772 Results.

PTO Pump Mounting Kit . Designed to help install a new PTO in minutes, the PTO Pump Mounting Kit makes switching PTO's from one tractor trailer to the next quick and easy. Simply clean the PTO shaft, grease it, and install the mounting kit. Built tough for years of future use. - 35.00 LBS | OEM Part Number: CMKF12-6700-P8-AC