May 4, 2013 · The access hole needs to meet the geometry of D1.8. that's why they have those dimensions there to give the fabricator guidance on what size to make the access hole. By …

Mar 12, 2019 · If CJP can be made without weld access hole , than which welding process is most suitable for it? By SWN1158 Date 03-12-2019 11:52 If you’re welds are required to meet D1.1 …

Jul 12, 2007 · Doing so could create the very same cracking problems the weld access hole was used to prevent. D1.1 commentary states that welded closure of weld access holes is not …

Jun 30, 2013 · Pre-heat: Max inter-pass temp, re-entrant corners, Weld Access hole geometry, joint configurations, welding processes that qualify as Pre-Approved, welder testing for …

Feb 12, 2020 · With regard to filling access holes, they should not be filled with weld metal, because doing so could initiate the very same cracking problems the weld access hole was …

Jan 5, 2018 · Specifically the following:" All weld access holes shall have a length from the edge of the weld joint preparation at the inside surface not less than 1-1/2 times the thickness of the …

Jun 28, 2012 · In the event the detailer decides the entire connection should be welded, i.e., the top and bottom flanges welded to the column flange, as well as the web to the column flange, …

Mar 12, 2010 · Is possible made weld access hole in column with bases plate? The column is Build-Up member (Welded Plate 1in flange and 5/8in web and bases plate 1-1/4 in). I have …

Jul 29, 2013 · Most of the time the joint in question will be a single bevel groove weld with backing. Instead of welding through the weld access hole, which would then require the …

Jul 16, 2010 · I got this from AISC Site Weld access holes should not be filled with weld metal -- doing so could create the very same cracking problems the weld access hole was used to …